Sanson was built in 1951 by Shipbuilders & is a carvel planked semi-displacement classic launch, approx. 25′ in length. Zoom zoom comes from a 2 cylinder 25hp Shibaru Ford diesel engine.
That is about all I know about her, can any woodys (Northland based – she lives near Dove Cove) help out with more details?
MEM SAHIB
Mem Sahib is a 1965 16’ Seacraft Runabout that thanks to owner Dan Kamphuis has been restored to better than new condition, so good in fact that she was an exhibition at the 2011 Auckland Boat Show. The restoration started in 2009 and took 16 months, post the work – Lionel Sands from ‘Seacraft-Hanes Hunter’ viewed the boat and said it is one of the best restorations he has seen in a long time.
In addition to the physical (wood) side of the project, she received new electrics and bilge pump. The zoom, zoom comes from a Mercury 2006 60hp motor that must really push the 16’ hull along.
Dan knows a little about her past and was able to track down the owners before him and these people (EJ & KV Ralph) restored the boat in 1988. They said that they purchased the boat from a Canadian chap in Takapuna and the boat had been sunk on the ramp at Takapuna beach as they had left the bungs out. The wife was holding the rope to the boat while her husband was getting the car and did not realise the boat was sinking! It sat at their place for 18 months before Keith Ralph and his dad bought it. They restored it and sold it to their uncle Frank Mudrovich who left it standing covered outside for years. It was given to his nephew Ivan and Dan in 2008 and put under cover for a restoration project. However Ivan left it to Dan due to other commitments and Dan started the restoration in 2009 and as mentioned above, put it into the Auckland Boat show in 2011.
Talking to Dan, he is a one of those people that always has a project on the go and has the skills to undertake restoration projects like Mem Sahib. I fact post completing the project she has been used very little, but regularly serviced & run.
Now Dan has a problem, the next project is about to arrive & he needs shed space so Mem Sahib must go. So if any woodys out there are looking for a small classic that due to its size & presentation (small amount of varnish) is very easily maintained, Mem Sahib is a great buy at $20k ono. Comes with a trailer that is all registered and WOF and the motor was serviced recently by a Mercury dealer.
Would be a very smart, practical lake boat………….
I don’t normally publish owner details but I like this boat & she deserves a woody owner so if your interested or know someone who might be, contact Dan at mkamphuis@vodafone.co.nz
ALDEN KETCH – Sailing Sunday
We do not see a lot of John Alden designed classic’s in NZ which given they are almost always very pretty vessels, isn’t good.
This one was design #550 & was built in 1939 by Arnold France in Lyttleton & has been lovingly restored by her current owner.
She is 39.35′ & built with full length 1 1/4″ oregon on hardwood frames. Her when the sails aren’t up a 2012 Nissan TD27 88hp diesel pushes her along.
She was re-rigged in Her refurbishment included being rewired, new switches / breaker panels, batteries, instruments, electric toilet and holding tank, new plumbing throughout. Plus new squabs and many other extras, complete hull paint before Christmas.
She is for sale on trademe – a very smart classic & a lot of boat for the asking price of $65k ono
02-04-2017 Updates from Robin Elliott
She is Windswift and was registered as A-8 with Banks Peninsular Cruising Club, She was a 3 year building project by Arnold France.
France probably started building her in 1939 but she wasn’t launched until October 1941. He and his wife and son lived aboard for 3 years during the War.
Seems to have grown a little over the years. Reported as 35-feet when launched, Arnold France gave dims of “33ft 8in x 10ft 6in x 4ft 8in” in 1949, In December 1956 she was advertised for sale as being 34-feet. She was on Trade Me in 2008 as 41-feet, and now as 39.35ft. Tricky things these Alden ketches.
Here’s a little bit more, courtesy of Papers Past
https://paperspast.natlib.govt.nz/newspapers/CHP19411030.2.63?query=arnold%20france
https://paperspast.natlib.govt.nz/newspapers/LWM19460509.2.22?query=arnold%20france
YVONNE
The 38′ classic launch Yvonne was built in 1954 by Swanson in the Marlborough Sounds. She is a very distinctive design & with a 160hp Isuzu diesel she must left her skirt & really get up & go. Based in the Sounds & after 22 years of ownership, Yvonne is now ready for a new owner. Thx to Ian McDonald for the trademe heads up 🙂
Anyone able to supply more details on her?
Input from John Wicks
“Very “avante garde” styling for the time – and still looking good!!!
Bob Swanson built her at Blackwood Bay, Queen Charlotte Sound, for Jack Thompson, a farmer out Ward way, who kept her for many years – could be she’s only had 2 owners? Jack named after his wife, Yvonne, a very gracious lady.
Can’t remember what her original engine was, but I do recall Jack talking about the possibility of putting in a small gas turbine. At the time there were experiments overseas with these, but I don’t know how serious he was.
Jack was a friend of my father’s (Sorry Alan) and when the first Picton marina was built they moved into adjacent berths. IIRC this involved a certain amount of the testing of water purifying fluids.”
05-05-2017 – A Peek Down Below
Thanks to the photos below ex Jo Utting (owners family) via Ken Ricketts we get a glimpse of what must be her original interior.
LANES BRIDGEDECK LAUNCH
Given the recent debate on ww as to what constitutes a bridge-decker, today’s boat has the potential to have a major identity crisis 🙂 But if we park the owners trademe description & just take the boat on face value, she a pretty looking classic wooden launch.
Built by Lanes Boatbuilders in 1915, she is 30′ in length & built with carvel kauri planks & her decks are plyed / glassed.
Her owner has had her for 20 years & uses her regularly. Back in 2000>2003 she had a total refit (refer above photos).
Zoom zoom is via a Standard 23C engine, which is an early (1958) 35hp Massey Fergusson 4 cylinder, 2200cc. This easily sees her cruising at her hull speed & 7 knots is a comfortable speed without pushing anything too hard.
I like this classic & at $26k she would make a very affordable entry into classic wooden boating. Spend a few dollars & she could be made very special.
Sorry no name – so the question, as always 😉 woodys is, who is she & what do we know about her?
PRIMADONNA
Primadonna is a 36′, 1905 whale chaser built by Lanes for a family with a farm in Tory Channel. Was used as a whale chaser until the end of the whaling era and then became a farm transportation boat for the same family who owned her till her current owner bought her.
She is built out of double diagonal kauri and powered with a 72hp Ford. Cruises at about 8 0r 9 knots at 1500 revs. She has accommodation for 2 and a small wheel house which you can steer from inside of the weather goes bad. Currently 4sale on trademe- thanks to Ian McDonald for the heads up.
Harold Kidd Input
There’s a bit of manufactured history here. Ernie Lane didn’t come to Picton until 1907 and doesn’t appear to have built PRIMA DONNA. Most authorities say she was built by Alf Baldick between 1910 and 1915 for himself and Derbyshire as a whalechaser to compete with the Peranos. She remained in the ownership of the Baldick family until at least 2001.
She’s been on WW before; see https://waitematawoodys.com/2017/02/27/welly-woodys/
PS the “second generation” of whalechasers used by the Baldicks were SUSSEX and PEERLESS, in competition with the Peranos’ CRESCENT, BALAENA and CACHALOT. Ernie Lane built SUSSEX and PEERLESS for the Baldicks in 1916. Lane built the Peranos’ CRESCENT and BALAENA but CACHALOT was built in 1916 to a design by Chas. Collings by Kensitt at Picton. She was the THIRD generation of whalechaser and had a 130/150 hp Van Blerck, typical Collings’ concave-convex hard chine planing hull.
Update 24-05-2020 photos below added ex trademe listing
ARAWA
The above 45′ Gladden pilot house bridge-decker was built in 1972. Powered by twin Ford 180hp diesels that get her along at 10>14 knots. Thats about all I know, photos ex trademe.
Can anyone put a name to her & some history? (see comments section – lots of info there )
Sorry about the poor image used as the main photo but that was all there was available.
Photos below ex Brian Worthington & Ken Ricketts
TAWERA 1935 LOGAN – A18
Tawera was launched on 30th December, 1935. Tawera was designed by Arch Logan and built by Colin Wild of Stanley Bay, Devonport. Her first race was the Auckland Anniversary Regatta in January 1936.
She was Arch Logans last big cutter, measuring almost 50 feet on deck and the culmination of a number of racing keelers built at that time. As the largest of the more modern keelers from Arch Logans drawing board she represented the very best in design development and to this day still epitomises all of the racing winning and wholesome sea keeping abilities of Arch Logans designs.
Tawera is immaculate and has been extensively restored and is now considered one of the finest examples of the a keeler of the pre-WWII era. Her owner is one of the Classic Yacht Associations most loyal members & has loved her as a Logan should be & spared nothing on her maintenance & restoration. She is for sale & is I believe amazing value for money.
Her recent restoration was to the highest specification which includes the building of a new spruce mast to the original specs, new Volvo Penta engine, and redevelopment of the saloon, galley, heads and fore cabin. A new wooden spinnaker pole and wooden turning blocks on deck as well as an all new sail wardrobe consisting of Mainsail, #1, #2 genoas, asymmetric and conventional spinnakers.
Anyone interested in acquiring one of, if not, the best Logan a float could contact me on waitematawoodys@gmail.com & I’ll pass details on to the owner 🙂
MOANANUI
Moananui was launched in 1950, is 28′, carvel built from kauri & powered by a 1970 60hp Ford (Ebro) diesel. Thanks to Ian McDonald for the trademe heads up 🙂
Anyone able to supply more details on her?
Home Needed – Seacraft Run-about
While out & about Mori Flapan came across the interesting small clinker runabout above, in a café at Rawene in Northland.
It is 12.4′ long and has a steering wheel marked ‘Seacraft Ltd, Auckland’. The history of the Sea Craft Ltd company can be found at http://www.mmsc.co.nz/history Makes for some interesting reading, particularly Yeoman Lionel Sands’ story, and the introduction of fibreglass.
The boat originally was an inboard, but the engine has been removed and transom cut to mount an outboard. However, a rudder with the boat looks like it might have been original.
The café owner told Mori that she is looking to dispose of the boat in the near future. She has had plenty of offers from locals to take the boat and use it as a garden ornament filled with soil and plants, but she hopes that the boat might have a better fate.
If there is anyone interested in the boat, contact Mori at mflapan@gmail.com & he will pass details on to the cafe.
waitematawoodys.com #1 for classic wooden boat stories, info, advice & news - updated daily - 15+ million views 