LADY CAROLE REFIT – Update #1

As mention previously the launch – LADY CAROLE has just commenced a refit that will see her returned to as launched configuration (or very close). The project is being overseen by co-owner Patrick Crawshaw and Patrick has agreed to report into WW with updates on the work. Patrick is a talented and articulate gent so I’ll hand over to him to tell the story:

“She came out on the 30th of May and is now on the hard in the Bay of Islands. First job was to remove all the plastic bits and pieces she had accumulated over time. Then the chrome and rub rails came off. Once she was stripped, we could see what we had, and already she was a better looking boat. Since then we have been sanding – a lot of sanding!  And many discussions and decisions around how best to return her lines and original appearance. 

A lot of thought has gone into the colour scheme in order to pop the lines again. In one of the photographs, you’ll see where we have put a makeshift pipe to know where that mid section line was (we had to do this by eye) and also to know where the windows need to be reduced to.  We will have to do the windows by eye/photograph as well so we are filling the whole section, then cutting them out.  

One problem was, the ceiling in the main cabin has been raised so we are going to re-cut the back curve so it lines up with the top of the windows, which will make that upper aft section look more elegant than it is at the moment – if you compare the 1950’s b/w photo to the now one, you’ll see what I mean. 

There has been much deliberation over the bowsprit, and as it’s glued and bolted down, we want to really work with it, so I have redrawn it to make it look more elegant.  

There were cuts along the side rail for water to drip down, but these have been filled today so we can get a sharp white pinstripe along the side that will contrast with the midnight blue hull and the red side section. 

The rub rails are copper and everything else is chrome, so I am going to treat them to make them black, which will pop the white pinstripe and work with the midnight blue. 

Great discussions over the glass windows – should they be tinted, or clear?   Originally they would have been clear so I think we are going for that. I would also like to replicate the striped curtains (seen in the 1950’s photo) in blinds, so you get that horizontal stripe from the fabric which looks great – So the fabric blinds need to be blue and white to work with the exterior colours. 

The mast is pretty knackered and has lost its cross rails, so we took the decision to make a new one. I’m in the process of designing this so will forward that on when it’s done. I want it to look very streamlined 50’s so taking those curves at the back and the new bowsprit design as inspiration so they all work together. 

We have fortunately found only a tiny bit of rot, so someone is smiling on us.

Another item is her stern and name – my grandfather put the duck board on her in the late 70’s, but before that she just had a ladder up the back (as seen the 1970’s photo) so in order to centralise the lettering properly we are going to raise that aft entrance cut up and then put the letters in between the duck board and the bottom of the new line. 

I have some interior design drawings, which I need to finish, but will send these to you as well, so you can see what that cockpit and interior fit out will look like. “ (edited AH)