Recently, woody Angus Rogers sent in the top photos of HOTSPUR , a recently restored 24’ Mason Clipper that calls the Outdoor Boating Centre (OBC) in Auckland home.
Angus pointed her owner – Fraser Elder in the direction WW and Fraser sent in the gallery of photos of HOTSPUR.
This wasn’t a fast project, in fact Fraser commented that from start to finish it was 9 years, fitting it between work and family commitments.
Some background – HOTSPUR was built c.1968/1969 and during the restoration, several bits of the timber in the boat were numbered (as in the photo with H15 on the inside of the instrument panel) and they are numbered H15, H16 and H17. Fraser reinstalled these parts to keep the numbers in the boat. Puzzled about the presence of three numbers, Fraser spoke to Anne Mason about this, and was told ‘Oh that’s to be expected, we built the boats in threes’, so there was always an amount of cross pollination between the boats.
HOTSPUR was built with a fibreglass hull, after the first tranche of builds with a timber hull, but there is a lot of mahogany in her. During the restoration Fraser needed to replace a high percentage of that timber, using sapele, as real mahogany is no longer allowed to be sold because of the CITES agreement.
Before the restoration, she had a BMW D150 (around 140HP) diesel engine. However, this had several parts that were too corroded or rusted too be used and very hard, or impossible to replace because of the age of the engine. So Fraser installed the BMW D190 (around 180HP) that he had purchased along with the boat. It was also newer and had, he was told had been rebuilt, although this is later questioned. It is this engine that you see running in the boat after he had figured out the few issues he had getting the engine started.
The restoration was mainly completed around August 2022 after nine years but as with any of these restorations, there are still (mainly small) tasks to do, and things that Fraser will eventually get around to, including replacing some of the work he did in the early days, as he says he is now more skilled 🙂 and more knowledgeable about some the techniques to use.
During the second half of 2025 Sven Wiig was undertaking in Wellington a major refit on the ex work boat ARIANA , previously named GLENROWAN and TE KAWAU. WW covered the project in three parts – links below. Last week Sven updated WW on the final push to getting her back in the water.. As we learnt previously Sven has reverted back to the original name – TE KAWAU, we like that 🙂
As previously I will hand over to Sven to tell the story. Enjoy – its a great read.
“Time for an update on the Te Kawau project. Winter had me up in Auckland with work. Returning to Wellington in the early spring I got back into the project with fresh energy. First up was the wheelhouse sole. I built a new structure and cut out hardwood ply to line it. Pretty basic but a vast improvement on what had been there. The small cabin I had created out of the old fish hold got the same treatment.
Time to move outside. First up I fitted a hardwood seat to the stern. This was a request from Jessica. She has visions of lunches out on the rear deck.
With these projects out of the way and summer rapidly approaching it was time to get started on the hull.
I started scraping the old antifoul off. Two or three days passed and I had less than a third of the starboard side stripped. Was definitely going to need to find a more efficient process. I experimented with a heat gun and various sanders no luck the old paint was rock solid. Eventually I settled on burning the paint off with a LPG torch. Much more efficient but slightly terrifying. In the space of a couple of weeks I had the whole hull back to bare timber. I raked all the seams out discovering that the whole garboard had previously been filled with mortar. Apparently, this was quite common on old work boats. It had however really damaged the edges of the seam. I decided that it needed some repair and most of it was tidied up and I glued Kauri splines onto the plank edge. There were several other areas that needed a similar treatment. I also removed all the old skin fittings and through-hulls. All seams were given a coat of red lead paint.
I then got a lesson in caulking from one of the old boat builders who is often around the yard. With this new knowledge I set about re-caulking the boat. This is a task that I had been dreading as it had seemed like a dark art, with people warning me it was hard. As it turns out I quickly got a feel for it and fortunately my brother arrived for his summer visit just in time to finish the caulking and get the seams puttied. The putty proved to be much harder work than the caulking. As my boat builder friend advised me “If your hands aren’t aching at the end of the day you are doing it wrong.” A couple of weeks later I had the first coats of primer on and Te Kawau was looking better than she had in a long time.
The race was now on to get her in the water before my next work project started. The systems all needed sorting out. I spent a couple of weeks plumbing the new tanks sorting out wiring, installing a new hydraulic steering system, etc, etc. Antifouling and propspeed were applied and finally she was ready for launch. Couldn’t quite believe that I had got to this point. There were plenty of times along the journey that I thought she was never going back it the water. One fine Sunday in early February with little drama she was put back in the water. I was expecting that she would have water gushing in but as it turns out the water ingress was not too dramatic and slowly she is taking up.
There is still plenty to do. The interior has to go back in and both sleeping cabins will need fitting out but in the mean time we can get out and enjoy her.
PAIHIA – BAY of ISLAND – PLEASANTLY SURPRISED I haven’t been to Paihia in a very long time, like 35+ years, tend to dodge it when driving north + I do not have good memories having nearly bleed out in an encounter between a plate glass door and an artery. We traveled north to perform babysitting duties while daughter was doing bridesmaid duties at a wedding. While still a tab OTT touristy / Rotovegas, I was impressed. Won’t bore you with too much but Sunday breakfast at Zane Grey’s, over the water was very good on all fronts – location, setting, service, food and price. Only spotted one woody at anchor.
WHAT DO ALL THESE CLASSIC WOODEN CRAFT HAVE IN COMMON
As I have noted recently on WW the classic wooden boating scene in the Bay of Islands is experiencing a re-birth. Seems one in three woodys the Wooden Boat Bureau has sold in the last 2 years has headed north. And recently the woody skippers have been organising events to show case the woody movement in the B.O.I. – we like that.
At the recent Russell Tall Ships Regatta on the Friday prior to the sailing regatta there was a Classic Launch Parade that had 13 woodys participating. Post the parade one of the skippers pointed out the % of woody craft that owed their good looks to time spent at the CMC Design – Boatbuilders Opua yard. So I did a count and in recent times and in no particular order the following woodys have been under the care of the talented crew at CMC Design – LADY CROSSLEY, KORAWAI, OTEHEI, MARLINE and ALMA G II.
Now they aren’t the only boatbuilders up north but they seem to get the cream of the work. When you factor in haul-out yard costs in the greater Auckland area, a wee road trip on one of the specialist boat haulage trucks isn’t the budget stumbling block it once was.
If todays WW story reads like an ad, I suppose it is, I’m passionate about seeing our classic fleet get the TLC they deserve. Check out the CMC website – some great work-in-process photos on their work + its not all boats, some stunning architectural and commercial wood work. https://www.cmcdesign.co.nz/marine
28-02-2026 UPDATE – video below of the LADY CROSSLEY project
Dropped into the Slipway Milford earlier in the week and the timing was perfect – the Dick Lang built launch NGAHI was being hauled out for some TLC and system improvements.
In previous WW stories there has been a lot of debate re the boats provenance, would be nice to confirm the builder and put a year to launching.
The Slipway Milford had a full quota of woodys on the yard – the JB Brooke designed and built yacht – GLEAM, now back in the Brooke family armada.
Along side NGAHI is the 35’6” Lane Motor Boat Co. 1945 launch – HANI (Wanda II) getting some serious TLC.
Both GLEAM and HANI are on display at next months Auckland Wooden Boat Festival, no doubt the marine chandlers are doing a good trade in varnish at the moment 🙂
SERIOUSLY……………… During a peek down below on NGAHI I spotted some VERY dodgy fittings – refer below. No seacocks and single jubilee clips the only thing between floating and joining the submariners club……………. you’d like to think this wasn’t a ‘professional’ installation.
UPDATE – That was quick, looking more fitting of an ocean going craft 😉
Just before xmas WAIREKA was popped back in the water (Bay of Islands) looking stunning. Looking forward to getting some interior photos ………… hint hint 🙂
16-02-2026 UPDATE – A sneal peek at the interior – floor coverings to come.
Recently WW was contacted by Robert Williams concerning the launch – LADY LUCK. I need to take a deep breath when I read the email – why?, well turns out LADY Luck is a 38ft Vindex built by Jim Young, (unknown year). But a quick glance at the attached photos and I was pleasantly surprised with todays top photo – quite a looker in her day.But too sure about the look after someone got tired of sanding and varnishing.
She was part of the Auckland Volunteer Coastguard main rescue ‘Cutter Group’.
The photo showing the varnish sides was as she was leaving the Tamaki River after a thorough clean and repaint. The photos of her in mainly white colours was taken many years later in possibility Half Moon Bay Marina during the 1990’s.
Can we learn where LADY LUCK is these days.
INPUT ex BILL UPFOLD – Up until late last year Lady Luck was sitting outside a panel beater’s on Union St. Howick. it had been sitting there for a few years then disappeared. Not sure if it has been moved into a shed on the property or moved elsewhere.
INPUT ex ALAN SEXTON – Lady Luck is not a Vindex, she was a design from Jim that predated Vindex, he told the story in his self published memoirs
Todays woody story features the 35’ ketch rigged motorsailer- SOUTHERN BELLA, launched in 1960. She featured in the August 1961 edition of Sea Spray magazine.
In the top photo we see her preparing for launching at the Devonport Yacht Club. In the Sea Spray article , below, they described her as amateur designed and built by Barney and Peter Soljak (father & Son), alongside they Devonport home.
When launched she was powered by a 50hp BMC Commodore Diesel engine + a 4.5hp Lister auxiliary engine.
(Story and photos ex Sea Spray magazine via Ken Ricketts)
Southern Belle and Raiona B.O.I. – date unknown
Back in 2019 in another story, DYC related, Chris Leech commented at SOUTHERN BELLE had suffered fire damage and been restored. Chris supplied to photos , the first hauled out at DYC and afloat post repairs. Can we learn more about what happened and what became of SOUTHERN BELLE after this.
Chris Leech sent in the update below – “Great progress has been made over the break on Janace Anne. Below the waterline is just about ready for anti foul, the topsides have been stripped back, and given two coats of primer. The cabin top has been water blasted and ready for attention. Down below is has been tidied up, but the current plan is to only get the engine running. We have had the offer of a complete running engine (Bukh 10) if required. The original was handled by Moon Engines. Please visit woollacott.org.nz for more photos in info + some below.”
— WAITING ON A WW T-SHIRT ? – A few orders over the break went into the spam file – so if you think Im rude and have not got back to you – sorry – can you re0send your email – thanks
During a deep dive in the WW files I rediscovered an email received from Paul Garnham concerning the classic yacht RANGER. Refer below (edited)
“It was suggested to me that you might be able to assist me locate the current owner of Ranger. I’m currently digitising my Grandfathers old photos slides from the 1960’s and 70’s and discovered a bunch of photos of Ranger and crew sailing in the Bay of Islands as best I can tell. The owner of Ranger, Mr Tercel? features in a couple of them. I wonder if the current owner of Ranger might be interested or even your website?
I assume it was my Grandfather, Charles Garnham, who took the photos, and I can also identify one of the crew as Mac Redmond, who is my father’s cousin”.
Now I’m hoping I did connect the two, but if not hopefully todays story will.
RANGER also made an appearance on the cover of the Dec/Jan 1961/62 issue of Sea Spray magazine (photo below via K Ricketts)
CLASSIC WOODEN BIG GAME BOAT – DOROTHY – FLASHBACK
Back in July 2015 WW ran a great story on the Oliver & Gilpin built launch DOROTHY, link below. At the time we only had one every stunning b/w photograph https://waitematawoodys.com/2015/07/01/dorothy-2/ There is lots of chat on DOROTHY at the link.
Fast forward to late Dec 2025 and woody John Dawson sent in the great photo above .
Can we learn more about where she is today.
05-01-2025 – INPUT ex CRAIG OGLE – My old mate Wayne owned her in the 90s he sold her to a couple fellas in Wellington as far as I know.
